Knowledgebase:
Equilogic
Posted by , Last modified by Carl Ingram on 12 June 2013 04:56 PM
Applies to PS50e or Dell 5000 series.
 
notes;
Connect thru serial interface 
the equilogic ps50e, has 3 primary interfaces. (eo,e1,e2) per controller?. they must all be on te same subnet...
Setup has u configure (this system expets all interfaces to be on the same subnet);
  • the 1st interface (eth0)
  • then the group interface 

 

Links:

http://www.equallogic.com/resources/view.aspx?id=356

 

Notes;

the equalogic only works properly with the group ip in the newer revisions (since dell)
since the 2nd controller is passive, the scsi timeouts need to be increased (2x) to allow for controller failover.
There are several pdf available from equilogic on implmenting replication and failover.
(this active passive config presents using multi-pathing) 

(0 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).